100 Women's Sailing Jacket - Red
Ideal for several hours to a whole day of sailing. Waterproof, windproof and breathable, this women's sailing jacket features numerous pockets and an adjustable waist.
3 hours under fine rain (>4000 mm). Fully taped seams. Water repellent.
Resistance to salt water
Injected plastic zip. Treated membrane.
Highly breathable (RET<12, test complies with the ISO 11092 standard)
2 outer pockets + 1 inside pocket.
Fabric helps stop the windchill effect.
Main fabric : 100.0% Polyamide (PA) Main lining : 100.0% Polyamide (PA) Secondary lining : 100.0% Polyester (PES) Yoke : 100.0% Polyamide (PA)
occasional inshore sailors (3 to 4 half days per year) under fine rain.
Store in a dry place, but do not leave your garment on a heat source such as a radiator, as this may damage the breathable membrane or coating.
FEATURES OF THE PRODUCT
- Water repellent coated fabric. - Fully taped seams. - Adjustable waist with elasticated cord - Sleeve cuffs adjustable at the wrist with rip-tab strips. - Zip fastening protected by internal and external zip flaps. - Collar height (rear): 12.5 cm - > 5,000 mm in Schmerber test (>2,000 mm after 5 washes) - Removable hood, adjustable with an elasticated cord, and adjustable depth. - Tested under a simulated fine rain shower (100 L/hr/sqm) for 3 hours.
RET <12: very breathable. To find out whether a fabric is breathable, we measure its evaporative resistance, or RET, (test based on the ISO 11092 standard). It is its ability to allow the water vapour produced by the body during exercise to escape.
709 g in EU size 40
RESISTANCE TO WEAR
- Injected plastic central zip resistant to salt oxidation.
HOW TO REACTIVE THE JACKET'S WATER REPELLENCY? step 1: before washing
Close all zips and flaps and remove any parts of the garment that cannot be washed. Also remember to loosen the straps and elastic parts and empty the pockets. Then turn the garment inside out to wash it.
HOW TO REACTIVE THE JACKET'S WATER REPELLENCY? step 2: washing
You can wash your jacket on a synthetic cycle at 30° or 40°C with your usual detergent. Do not use fabric conditioner, which could damage the existing performance of the garment, or bleach. Also take care not to bend your jacket too much when you place it in the washing machine and do not overload your machine.
HOW TO REACTIVE THE JACKET'S WATER REPELLENCY? step 3: drying
Drying is a crucial phase in reactivating the water repellent treatment. We recommend that you lay your jacket flat on a clothes rack and leave it out to dry in the open. Caution: never dry your jacket directly on a radiator. Then place it in the tumble dryer on a short synthetics cycle, i.e. 10 to 15 minutes, before turning it back the right way round. Caution: do not over-dry the garment.
HOW TO REACTIVE THE JACKET'S WATER REPELLENCY?
If, despite this procedure of washing and thorough rinsing followed by gentle drying in a tumble dryer, the drops of water no longer run off the surface of your jacket, we recommend that you "re-waterproof" it using a waterproofing spray or detergent sold in our stores.
* The prices listed on the site are the prices recommended by DECATHLON SA's central purchasing department.